TIR E-CHIP® Large Coil VALVE

Texas Industrial Remcor is proud to announce the next step in solenoid valve development with our new TIR E-CHIP®. By integrating a small interface electronic board into the valve, the power consumption, input voltage, and operating temperatures are reduced.

Upon the introduction of power, the driver allows full current to the valve during a time called “Pull-in.” After “Pull-in,” amperage is reduced by 66% of normal valve amperage requirements. With this integration of the TIR E-CHIP®, coil discharge that causes reverse voltage also becomes less of an issue.

The TIR E-CHIP® can be installed in all 2-way Weather Pack solenoid valves.

EQUIPMENT STANDARDS:

- TIR E-Chip® Installation

- Weather Pack Connectors

 
 

TIR 1.1A Solenoid Comparison

(running dry at 5 mph at 70 °F)

degrees °F501001502002502.0 Miles31.0 Blocks1.6 Miles24.5 Blocks1 Mile15.5 Blocks3/4 Mile11.0 Blocks1/2 Mile6.75 Blocks1/4 Mile2 Blockstir e-chip™standard coil

TIR 2.0A Solenoid Comparison

(running dry at 5 mph at 70 °F)

degrees °F501001502002502.0 Miles31.0 Blocks1.6 Miles24.5 Blocks1 Mile15.5 Blocks3/4 Mile11.0 Blocks1/2 Mile6.75 Blocks1/4 Mile2 Blockstir e-chip™standard coil