TIR E-CHIP™ VALVES

TIR E-CHIP™ valves

Texas Industrial Remcor is proud to announce the next step in solenoid valve development with our new TIR E-Chip™. By integrating a small interface electronic board into the valve, the power consumption, input voltage, and operating temperatures are reduced.

Upon the introduction of power, the driver allows full current to the valve during a time called “Pull-in.” After “Pull-in,” amperage is reduced by 66% of normal valve amperage requirements. With this integration of the TIR E-Chip™, coil discharge that causes reverse voltage also becomes less of an issue.

The TIR E-Chip™ can be installed in all 2-way Weather Pack solenoid valves.

EQUIPMENT STANDARDS:

– TIR E-Chip™ Installation

– Weather Pack Connectors

View Catalogs

TIR 1.1A SOLENOID COMPARISON

degrees °F 50 100 150 200 250 2.0 Miles 31.0 Blocks 1.6 Miles 24.5 Blocks 1 Mile 15.5 Blocks 3/4 Mile 11.0 Blocks 1/2 Mile 6.75 Blocks 1/4 Mile 2 Blocks tir e-chip™ standard coil

TIR 2.0A SOLENOID COMPARISON

degrees °F 50 100 150 200 250 2.0 Miles 31.0 Blocks 1.6 Miles 24.5 Blocks 1 Mile 15.5 Blocks 3/4 Mile 11.0 Blocks 1/2 Mile 6.75 Blocks 1/4 Mile 2 Blocks tir e-chip™ standard coil